Yamaha TF5 Digital Mixer

Baseret på 4 anmeldelser

35.590 kr.

Vi prismatcher i
Tilbehør der passer til
stk.

Tilbehør der passer til

Vi tilbyder attraktiv leasing
5-stjernet Kundeservice
  • Høj input-kapacitet
  • Mange fadere gør dette til den perfekte pult til større arrangementer

Varenr.: YAM-TF5
EAN: 4957812560238
Vægt 20

Specifikationer

Outline

Fader Configuration 32 + 1 (Master)
Mixing Capacity Input Channels 48 (40 mono + 2 stereo + 2 return)
Aux Buses 20 (8 mono + 6 stereo)
Stereo Buses 1
Sub Buses 1
Input channel functions 8 DCA-grupper
I/O Inputs 32 mic/line (XLR/TRS combo) + 2 stereo line (phono)
Outputs 16 (XLR)
Expansion slots 1
On-board processors DSP 8 effekter + 10 GEQ
USB 34x34 USB Audio Interface, 2-spors indspilning til USB-stick

General specifications

Sampling frequency rate Internal 48 kHz
Signal delay Mindre end 2.6 ms, INPUT til OMNI OUT, Fs=48 kHz
Fader 100 mm motoriserede, opløsning = 10-bit, +10 dB to –138 dB, –∞ dB alle fadere
Total harmonic distortion Mindre end 0.05% 20 Hz–20 kHz @+4 dBu ind i 600 ohm, INPUT til OMNI OUT, Input Gain=Min. (Målt med et –18 dB/oktav filter@80 kHz)
Frequency response +0.5, –1.5 dB 20 Hz–20 kHz, ved +4 dBu output @1kHz, INPUT til OMNI OUT
Dynamic range 110 dB typ., DA-konverter, 107 dB typ., INPUT til OMNI OUT, Input Gain=Min.
Hum & noise level Equivalent input noise –128 dBu typ., Input Gain=Max. (Målt med A-vægtningsfilter)
Residual output noise –85 dBu, ST master off (Målt med A-vægtningsfilter)
Crosstalk –100 dB (Målt med et –30 dB/oktav filter@22 kHz), fortløbende INPUT/OMNI OUT-kanaler, Input Gain=Min.
Power requirements 100–240 V 50/60 Hz
Power consumption 120 W
Dimensions W 866 mm (34.1in)
H 225 mm (8.9in)
D 599 mm (23.6in)

Generelle specifikationer

Nettovægt 20.0 kg (44.1lb)

General specifications

Accessories Quick Guide, Strømkabel, CUBASE AI download information
Options Udvidelseskort, fodpedal (FC5)
Others Arbejdstemperatur: 0–40 °C, Opbevaringtemperatur: -20–60 °C

Analog input characteristics

Input Terminals GAIN Load
Impedance		 For Use With
Nominal		 Input Level Connector balanced /
Unbalanced
Sensitivity*1 Nominal Max. before clip
INPUT1-32 +66dB 7.5KΩ 50-600Ω Mics
or 600Ω Lines		 -82dBu (61.6V) -62dBu (0.616mV) -42dBu (6.16mV) Combo Jack (XLR-3-31 type *2
or TRS phone *3)		 Balanced
-6dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V)
ST IN 1,2 — 10kΩ 600Ω Lines -30dBV (31.6V) -10dBV (316mV) +10dBV (3.16V) RCA Pin Jack Unbalanced

*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.

Analog output characteristics

Output Terminals Source
Impedance		 For Use With
Nominal		 GAIN SW Output Level Connector balanced /
Unbalanced
Nominal Max. before clip
OMNI OUT 1-16 75Ω 600Ω Lines “+24dBu” position (default)
 		 +4dBu (1.23 V) +24dBu (12.3 V) XLR-3-32 type *1 Balanced
PHONES *3 100Ω 40Ω Phones — 3mW 75mW Stereo Phone Jack (TRS) *2 Unbalanced

*1.1: GND,2: HOT, 3: COLD 
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND 
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms. 
*All output DA converters are 24bit, 128times oversampling.

Digital input/output specifications

Terminals Format Data length Audio Connector
USB (TO HOST) USB 24bit 34ch input / 34ch output, PCM USB (B type)
iPad USB — Playback: MP3 or WAV file data / Record: WAV file data USB (A type)

 

Control I/O specifications

Terminals Format Level Connector
NETWORK IEEE802.3 10BASE-T/100Base-TX RJ-45
FOOT SW — — TS Phone